- Store
- >
- 3D Printed Parts
- >
- Servo Traverse frame and changeable drive gears
Servo Traverse frame and changeable drive gears
3D Printed servo traverse bracket to replace standard Heng Long/Taigen motor gearbox. Comes complete with 5 sizes (12T, 15T, 20T, 25T, 30T) of drive gear.
(See below for short videos for small medium and large drive gears effect on traverse speed)
Dimensions -
64mm Long
58mm Wide
18mm High (48mm with Servo)
Complete with 360 servo.
3DP traverse bracket and drive gears contains & Servo
3D Printed bracket (2 parts)
12T, 15T, 20T, 25T, 30T drive gear
2 x fixing screws
1 x 360 Servo (Plastic Geared)
Note
May contain sharp edges
No instructions provided
It is recommended to 2mm pilot drill before screwing in the fixing screws into 3DP parts
Parts are intentionally tight fit
These are printed to order so please allow a few more additional days before dispatch
Colour may vary
RCTE reserve the right to revise or remove the product without notice