- Store
- >
- Construction
- >
- Bruder Volvo A60H Conversion to RC Kit
Bruder Volvo A60H Conversion to RC Kit
3D Printed conversion kit for the Bruder Volvo A60H 6x6 Dump Truck.
NOW Version 3, with following improvements.
- Metal insert into the wheels for better fixing to motor shaft.
- Wheel redesigned so fit snuggly onto the motor housing increasing stiffness.
- Swivel redesigned to fit original Bruder model so less cutting away for easier install.
- Rear chassis plate with LED mounting block. Just drill 3mm or 5mm and insert LED. (not included)
Kit
This is our V3 3D printed kit using 12v actuators to lift the dump bucket.
2 x ESC (12V rated)
1 x High torque servo
6 x 100rpm 12v drive motors
2 x 12v lift actuators (lifting capacity 5kg)
1m Red & Black twin core cable
1 x 4 channel radio and receiver
1 x headlight kit
Use instructions V3.
A ready to run version is available here.
Conversion instructions can be downloaded here.
These kits contain over 120 hours of 3D printed parts so please expect no dispatch for 1 week after ordering.
Notes
Printed under license with FMD RC Construction
May contain sharp edges
Instructions provided, recommended for medium plus experience model makers
It is recommended to 2mm pilot drill before screwing in the fixing screws into 3DP parts
These are printed to order so please allow a few more additional days before dispatch
Parts are printed in yellow and black, yellow is not a perfect match to Bruder ABS plastic
Colour variations may occur between batches
RCTE reserve the right to revise or remove the product without notice
Excluded from our returns policy
|
|
|
|