IBU RVC Remote volume control
SKU:
2006
£25.00
£25.00
per item
The RVC module replaces the physical volume potentiometer, allowing to remote adjust the audio level using a spare receiver channel. A standard proportional radio (AM, FM, or 2.4 GHz) which provides servo PPM outputs can be used.
Specification
The RVC is a small board (approx. 1 inch x ½ inch) and is simply plugged between volume potentiometer connector of IBU2 or TPA and a spare receiver channel.
Setup
Connect the servo-like lead to you receiver, typically the 6th channel has a control knob which will act in a familiar way for regulation.
Turn ON the power to receiver by the main power switch for the IBU2, leaving the transmitter OFF
You now should see a green light steady ON
With the control knob set to minimum. Turn ON the transmitter, the green light should start to blink slowly
Increase the knob position to maximum, the green light should blink faster (according to knob position)
Now you can connect the other 3 pin plug cable to Volume Pot connector on IBU2 or TPA
Turn ON the IBU2 and make it play a sound and set the volume to desired level
Specification
The RVC is a small board (approx. 1 inch x ½ inch) and is simply plugged between volume potentiometer connector of IBU2 or TPA and a spare receiver channel.
Setup
Connect the servo-like lead to you receiver, typically the 6th channel has a control knob which will act in a familiar way for regulation.
Turn ON the power to receiver by the main power switch for the IBU2, leaving the transmitter OFF
You now should see a green light steady ON
With the control knob set to minimum. Turn ON the transmitter, the green light should start to blink slowly
Increase the knob position to maximum, the green light should blink faster (according to knob position)
Now you can connect the other 3 pin plug cable to Volume Pot connector on IBU2 or TPA
Turn ON the IBU2 and make it play a sound and set the volume to desired level
3 available